The insert is suitable for sleeved cards. The total material consumption was about 1.4 kg and took about 45 hours to print (but this depends on your printer). I printed the entire insert with a 0.4mm nozzle, with 0.2mm layer height and 10% infill. Please note this if your printer has a corresponding print bed. Matching the miniatures, the corresponding cards are stored in the back of the tray. Therefore, there is a small bulge in the front where you insert the miniatures. The trays are designed so that the miniatures can't fall out if you tilt the trays. But I also glued them additionally with plastic glue - see also last picture). It's a bit tight, so it should hold well. If you want to lay the tray flat, you have to insert the card holders (Cardinsert_Minitray_1 through 8) into the slots provided by yourself. In both variants it is possible to put the monster card into the tray. The 4 normal Monster Trays are designed to be placed either upright or flat on the table. If you do not have an Extra Dice Pack, then you print everything except the 5 STL files whose name begins with "Variant". In addition, there are 3 STL files in the STL file list where "Variant_exchange" appears in the name. ![]() In the STL files there are 5 STL files where the name starts with "Variant". If you have an extra Dice Pack, you will find a variant in the insert: The card boxes are equally usable as a draw pile and a discard pile.ģ Promo Characters from the SPIEL in Essen 2022 through the token and card boxes that can be used during the game). The insert is intended to help with faster set-up and tear-down, but also to support play (e.g.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |